Boiler Accessories

Boiler fittings and accessories

    * Safety valve :
         It is used to relieve pressure and prevent possible explosion of a boiler.

    * Water level indicators :
          They show the operator the level of fluid in the boiler , also known as a sight glass , water gauge orwater column is provided.

    * Bottom blowdown valves :
          They provide a means for removing solid particulates that condense and lie on the bottom of a boiler. As the name implies , this valve is usually located directly on the bottom of the boiler and is occasionally opened to use the pressure in the boiler to push these particulates out.

    * Continuous blowdown valve :
          This allows a small quantity of water to escape continuously. Its purpose is to prevent the water in the boiler becoming saturated with dissolved salts. Saturation would lead to foaming and cause water droplets to be carried over with the steam - a condition known as priming. Blowdown is also often used to monitor the chemistry of the boiler water.

    * Flash tank :
          High pressure blowdown enters this vessel where the steam can 'flash' safely and be used in a  low-pressure system or be vented to atmosphere while the  ambient pressure blowdown flows to drain.

    * Automatic blowdown/continuous Heat Recovery system :
          This system allows the boiler to blowdown only when makeup water is flowing to the boiler , thereby transferring the maximum amount of heat possible from the blowdown to the makeup water. No flash tank is generally needed as the blowdown discharged is close to the temperature of the makeup water.

    * Hand holes :
          They are steel plates installed in openings in "header" to allow foe inspections & installation of tubes and inspection of internal surfaces.

    * Steam drum internals :
          A series of screen , scrubber & cans(cyclone separators).

    * Low-water cutoof :
          It is a mechanical means (usually a float switch) that is used to turn off the burner of shut off fuel to the boiler to prevent it from running once the water goes below a certain point. If a boiler is "dry-fired" (burned without water in it) it can cause rupture or catastrophic failure.

    * Surface blowdown line :
          It provides a means for removing form or other lightweight non-condensible substance that tend to float on top of the water inside the boiler.

    * Circulating pump :
          It is designed to circulate water back to the boiler after it has expelled some of its heat.

    * Feedwater check valve or clack valve :
          A non-return stop valve in the feedwater line. This may be fitted to the side of the boiler , just below the water level or to the top of the boiler.

    * Top feed :
          A check valve (clack valve) in the feedwater line , mounted on top of the boiler. It is intended to reduce the nuisance of limescale. It does not prevent limescale formation but causes the limescale to be precipitaed in a powdery form which is easily washed out of the boiler.

    * Desuperheater tubes or bundles :
          A series of tubes or bundles of tubes in the water drum or the steam drum design to cool superheated steam. Thus is to supply auxiliary equipment that doesn't need  or may be damaged by or dry system.

    * Chemical injection line:
          A connection to add chemicals for controlling feedwater pH.